SYMBOLS

To make a proper circuit, we have to have certain knowledge of some terms, such as, whats an open or close circuit. If we see it alive we can affirm what would be an open one or close one, it´s obvious.

CLOSED CIRCUIT                                                   OPEN CIRCUIT

                          

But when we grow it to plasm what we are doing before just doing it´s much more difficult if you don´t know the symbols so today it´s what we are going to do, learning some useful symbols.

In this picture we can se the most common symbols to show if a circuit is open or closed or what type of current is passing through it.

         1)      Wires not joined.                             1) Voltage AC source

         2)      Inductor                                             2) Wires joined.  

             3)  Resistor                                             3) Switch (open)

         4)    Voltage DC source                          4) Current source

         5)     Capacitor     

                    

                                                                                       

There are more symbols that have to be taken into account, like finding the value of the bands in the resistors. This is nearly easy and this diagram shows you how to do it.

IMPORTANT PIECES OF A CIRCUIT

In this blog we are going to learn how to analyze a circuit.


First of a lll we have to now some basic things about the material required to produce a circuit, so in the first post this is what i´m going to explain.
To make a circuit in a practical way we require some basic things such as:

STRIPBOARD

Stripboard is a widely-used type of electronic prototyping board characterized of regular (rectangular) grid of holes, with wide parallel strips of copper cladding running in one direction all the way across one side of the board. In using the board, breaks are made in the tracks, usually around holes, to divide the strips into multiple electrical nodes. With care, it is possible to break between holes to allow for components that have two pin rows only one position apart such as twin row.

RESISTOR

A resistor is a passive two terminal electrical componen that implements electrical resistance as a circuit element. The current through a resistor is in direct proportionto the voltage across the resistor's terminals. Thus, the ratio of the voltage applied across a resistor's terminals to the intensity of current through the circuit is called resistance. This relation is represented by Ohm´s law.

WIRE

 

It´s use to carry the electricity through the circuit.

CROCODILE CLAMP

It´s a simple mechanical device for creating a temporary electrical connector.

POWER SUPPLY

MULTIMETER



A multimeter is an electronic measuring instrument that combines several measurement functions in one unit.

A power supply is a device that supplies electrical energy to one or more electric loads.

Once we now this terms we are ready to prepare and analyze an electric circuit.